WDS capturing Win 10 image

hi, i've been using windows wds in deploying , capturing devices our production computers. lately after purchased new units new staff, unfortunately new gen7 processors of intel doesn't support win 7 anymore, have no choice use win 10 operating system. 

so did prepare win 10 image installing of latest updates before doing sysprep. rebooted machine, selected 'capture image' , went thru capture process. after clicking on ok, saw usual capturing progress bar stays on 0%. 

though system hanged on me no didnt, can still click on cancel button , buttons greys out, meaning system didn't hang. 

tried using different switch(guessing might hardware failure) same result. 

is there issue win 10 capturing os via wds?

thanks

jeff

hi,

have check wdscapture log?

if don't enable wdscapture log,you follow these steps turn on:

to obtain trace log in wdscapture operation, follow these steps:

1. start capture windows pe boot image.
2. when capture wizard starts, press shift+f10 open command prompt.
3. enable tracing in wdscapture component. this, follow these steps:
   1. start registry editor.
   2. set following registry entry enable tracing in wdscapture component:
      
      hkey_local_machine\software\microsoft\tracing\wdscapture 
      
      name: enablefiletracing
      value type: reg_dword
      value data: 1
4. start second instance of wdscapture component. then, reproduce problem using second instance of wdscapture.
   
   note do not close original instance of wdscapture. if close original instance of wdscapture, windows pe restarts. instead, press alt+tab switch between instances of wdscapture.

the following trace log file generated:

x:\windows\tracing\wdscapture.log

---

best regards
cartman
please remember mark replies answers if help. if have feedback technet subscriber support, contact tnmff@microsoft.com

Windows Server  >  Windows Server General Forum